READ THIS FIRST!

Please review all instructions prior to beginning the process.

If you are connected by USB, you must make sure your firmware version
is at 1.07.  If you are connected via the parallel port the firmware
upgrade is not necessary.

NOTE: If you are connecting to the parallel port make sure that there
are no other parallel port devices installed on the PC.  If so,
uninstall them using instructions provided by their manufacturer.

To determine your firmware level press the "Reports" button on the
WC 490 control panel until you see "System Data", then press the Start
button.  The System Data list will print out.  At the bottom of the
page it should say flash ROM version 1.07, if the number is below 1.07
go to the Xerox XP support page and locate the firmware download file
"XP 490F.exe" along with the Installation Instructions.

If you installed your driver from the CD, you must first uninstall it
before installing the driver from the web page.
1) Click on Start, and then go to All Programs.
2) Locate the folder Xerox WorkCentre 490cx, then click on
Printer Driver Uninstaller


PRINT DRIVER INSTALLATION

1) Attach the appropriate communication cable. (Parallel or USB)
2) If present, close the Found New Hardware Wizard by clicking on
Cancel.
3) Exit all applications on the PC prior to installing the drivers.
4) Go to www.xerox.com, and click on "Drivers"
5) Locate: "Important! For information about Xerox printers and
Microsoft® Windows® XP, Click Here."  Click on the text "Click Here"
6) Locate WC 490 in the table and click on the text in the right hand column.
7) Click on the print driver file "XP 490P.exe"
8) Click on OPEN
9) Click on OK
10) Click on Continue Anyway
11) Click on OK
12) Reboot the computer.