Software Installation Instructions for WorkCentre M940-M950

***** IMPORTANT *****
Before installing this new software 
Uninstall any WorkCentre M940-M950 software by clicking "start", 
"All Programs", "Xerox WorkCentre M940-M950", "Uninstall Xerox 
WorkCentre M940-M950." At the Uninstall Xerox WorkCentre M940-M950
dialog box make sure all items are checked and click "uninstall."

***** IMPORTANT *****
If the Found New Hardware Wizard dialog appears before step #14 remove
the power plug and data cable from your M940-M950 and click "cancel."

1) Remove the M940-M950 power plug and data cable
2) At the Drivers & Download web site click on "uswxp124.exe"
3) Select "OK"
4) Select "Setup"
5) Select "Next"
6) Answer the Software License Agreement with "Yes or No"
7) Select "Next" for a Typical installation
8) Select "Next" at the choose Destination Location
9) When you have the CD which came with your M940-M950 ready, select 
"OK", then insert the CD when prompted
10) Select "Continue Anyway" and wait for the software to be installed
11) Remove the CD and click "OK"
12) Select "Finish" to shut down you PC. This may take several minutes.
13) Connect your data cable and power cord to the M940-M950. 
14) Turn on your PC
15) Ignore the small pop-up messages at the lower right side of the 
display. When the "Found New Hardware Wizard" dialogue box appears 
select "Next"
16) Select "Continue Anyway" to continue installing the M940-M950 
software at both of the Hardware Installation dialogues
17) Select "Next" to run the Diagnostic test
18) If any of the Diagnostic tests fail, check all cable connections 
and unplug the M940-M950 power cord, wait 10 seconds, then plug it 
in again. Select "Back" then "Next" to repeat the Diagnostic test. After
two attempts if any test fails select "Back" then "Skip" to complete 
installation.
19) Select "Next"
20) Select "Finish"
21) Select "Finish" on the Found New Hardware Wizard dialogue box
22) Your WorkCentre M940-M950 software installation is complete